Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection
1. Start and warm up the engine. 2. Shift the select lever to “P” or “N” range. 3. Depress the brake pedal and hold it. 4. Check “secondary pressure sensor voltage” by using Subaru Select Monitor while the engine is idling. Subaru Select Monitor > OPERATION Specification: Approx. 0.8 V 5. Check “secondary pressure sensor voltage” by using Subaru Select Monitor while the engine is stopped and the ignition switch is turned on. Subaru Select Monitor > OPERATION Specification: Approx. 0.5 V |
Removal
CAUTION:• Be sure to prevent water or oil from contacting the connector terminal of secondary pressure sensor. If adhesion occurs, replace with a new part.• When removing secondary pressur ...
Installation
CAUTION:• Be sure to prevent water or oil from contacting the connector terminal of secondary pressure sensor. If adhesion occurs, replace with a new part.• After installing the secondary ...
Other materials:
Steering warning light does not go off
DETECTING CONDITION:• Defective combination meter• Open circuit of harnessTROUBLE SYMPTOM:When starting the engine, the STEERING warning light continues to illuminate.STEPCHECKYESNO1.CHECK DTC.Read the DTC of the power steering control module using the Subaru Select Monitor. Read Diagno ...
