Subaru Legacy BN/BS (2015-2019) Service Manual: Secondary pressure sensor

Disassembly

1. Remove the snap ring.2. Remove the retaining plate, drive plate, driven plate and dish plate.3. Set the ST1, ST2 and ST3 to intermediate case.ST1 18762AA001COMPRESSOR SPECIAL TOOLST2 18763AA0 ...

Removal

CAUTION:• Be sure to prevent water or oil from contacting the connector terminal of secondary pressure sensor. If adhesion occurs, replace with a new part.• When removing secondary pressur ...

Other materials:

Diagnostics with phenomenon inspection
1. BEAM LEVEL CONTROL DOES NOT FUNCTIONCAUTION:• Before performing diagnosis, check the fuse in this circuit.• Initialization is required after replacing the auto headlight beam leveler CM.WIRING DIAGRAM:NOTE:For the coupling connector, refer to “WIRING SYSTEM”.Headlight beam ...