Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
CAUTION: • Be sure to prevent water or oil from contacting the connector terminal of secondary pressure sensor. If adhesion occurs, replace with a new part. • After installing the secondary pressure sensor, adjust the CVTF level. 1. Install the secondary pressure sensor. NOTE: • Use new O-rings. Tightening torque: 39 N·m (4.0 kgf-m, 28.8 ft-lb) 2. Connect the harness connector. 3. Lower the vehicle. 4. Connect the ground terminal to battery sensor. NOTE Tightening torque: 39 N·m (4.0 kgf-m, 28.8 ft-lb) |
Inspection
1. Start and warm up the engine.2. Shift the select lever to “P” or “N” range.3. Depress the brake pedal and hold it.4. Check “secondary pressure sensor voltage” by ...
Other materials:
Dtc p2530 ignition switch run position circuit
DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:Improper idlingCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE ...
