Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Continuously variable transmission(tr690) / Transmission mounting system / Inspection

• Check the crossmember for bends or damage.

• Check that the cushion rubber is not stiff, cracked or otherwise damaged.

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Lift up the vehicle.3. Remove the front exhaust pipe. Front Exhaust Pipe > REMOVAL4. Remove the center exhaust cover.5. Set the transmis ...

Installation

1. Install the rear cushion rubber on the transmission.Tightening torque:40 N·m (4.1 kgf-m, 29.5 ft-lb)2. Install the transmission rear crossmember.Tightening torque:T1: 35 N·m (3.6 kgf- ...

Other materials:

Dtc b1802 short in driver's airbag (to ground)
DIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:GND short circuit failure (shorted to ground in main harness, shorted to ground in roll connector, shorted to ground in driver’s airbag, shorted to ground in airbag CM internal circuit)CAUTION:Before performing ...