Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Lighting system / Srf off switch / Inspection

1. Measure the resistance between connector terminals.

Preparation tool:

Circuit tester

Terminal No.	Inspection conditions	Standard
1 — 4	OFF	1 M- or more
1 — 4	ON	Less than 1 -

2. Apply battery voltage between the connector terminals to check lighting condition of illumination inside the switch.

Terminal No.	Inspection conditions	Specification
2 (+) — 3 (−)	Apply battery voltage.	Light ON

3. Replace the SRF OFF switch if the inspection result is not within the standard value.

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the cover assembly - instrument panel LWR driver. Instrument Panel Lower Cover > REMOVAL3. Release the claws and remove the SRF O ...

Installation

1. Install the SRF OFF switch.2. Install the cover assembly - instrument panel LWR driver.3. Connect the ground terminal to battery sensor. NOTE ...

Other materials:

Dtc b2789 id code box communication
DTC DETECTING CONDITION:• When communication between keyless access CM and ID code box is interrupted for a set amount of time.• Open or short circuit in the wiring harness between keyless access CM and ID code boxTROUBLE SYMPTOM:Engine will not start.CAUTION:For replacement procedure of ...