Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Security and locks / Access key / Inspection

1. ACCESS KEY BATTERY

Measure the access key battery voltage.

Preparation tool:

Circuit tester

NOTE:

Complete the measurement within 5 seconds because the battery discharges during measurement.

Battery terminal	Inspection conditions	Standard
(+) — (−)	Connect resistor (A) 47 -	2.5 — 3.0 V

Replace the battery if the inspection result is not within the standard value. (Use CR2032 V or equivalent.)

Replacement

1. ACCESS KEY REGISTRATIONNOTE:• A maximum of seven access keys can be registered for each individual vehicle.• When replacing or adding an access key, new registration of the access key i ...

NOTE:Refer to keyless transmitter for model without keyless access with push button start. Keyless Transmitter > REMOVAL1. ACCESS KEY BATTERYCAUTION:To prevent static electricity damage to the access ...

Other materials:

Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the trunk trim panel assembly - side on the RH side. (Sedan model) Rear Quarter Trim > REMOVAL3. Remove the right side rear quarter trim. (OUTBACK model) Rear Quarter Trim > REMOVAL4. Remove the fuel pump control unit.• Se ...