Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection
1. Check the setting by performing Keyless access system check using the Subaru Select Monitor. Keyless Access System Check > OPERATION 2. Disconnect the Subaru Select Monitor. After placing the access key near the changed antenna, operate the push button ignition switch to check that the power can be switched. 3. If the system does not operate normally as the result of inspection, refer to “General Diagnostic Table” of the “KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS)” section. General Diagnostic Table > INSPECTION |
Removal
1. FRONT ANTENNA1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE2. Remove the cover assembly - front and the console box assembly ...
Installation
1. FRONT ANTENNA1. Install the front antenna assembly - interior.2. Install the console front duct.3. Install the pocket assembly - CTR. External Connection Terminal > REMOVAL4. Install the console b ...
Other materials:
Warning and indicator lights
Several of the warning and indicator lights
illuminate momentarily and then go out
when the ignition switch is initially turned
to the "ON" position. This permits checking
the operation of the bulbs.
Apply the parking brake and turn the
ignition switch to the "ON" position. For
the system c ...
