Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection
1. Check the setting by performing Keyless access system check using the Subaru Select Monitor. Keyless Access System Check > OPERATION 2. Disconnect the Subaru Select Monitor. While bringing the access key, operate the touch sensor on door handle to check if door lock or unlock operates. 3. Disconnect the Subaru Select Monitor. While bringing the access key, operate the opener switch on the rear gate and the lock request switch to check if the door lock or lock operates. (OUTBACK model) 4. Disconnect the Subaru Select Monitor. While bringing the access key, operate the trunk opener button to check if the trunk is opened. (Sedan model) 5. If the system does not operate normally as the result of inspection, refer to “General Diagnostic Table” of the “KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS)” section. General Diagnostic Table > INSPECTION |
Removal
1. FRONT ANTENNACAUTION:Do not detach the antenna from the front door outer handle.If replacement is required, replace the front outer handle assembly as a whole.1. Disconnect the ground terminal from ...
Installation
1. FRONT ANTENNACAUTION:Do not detach the antenna from the front door outer handle.If replacement is required, replace the front outer handle assembly as a whole.1. Install the handle - door outer. F ...
Other materials:
Dtc p0122 throttle/pedal position sensor/switch "a" circuit low
DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Improper idling• Engine stalls.• Poor driving performanceCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PRO ...
