Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Security and locks / Keyless buzzer / Inspection

• Using the Subaru Select Monitor, set the volume of the keyless buzzer. User Customizing

• Using the Subaru Select Monitor, perform forced operation of the keyless buzzer. User Customizing > OPERATION

If the buzzer does not sound, replace the keyless buzzer.

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the keyless buzzer.(1) Remove the clips, and turn over the mud guard - front.(2) Disconnect the connector.(3) Remove the clip and ...

Installation

CAUTION:Install the mud guard - front so that the front end of the mud guard (b) comes outside the bumper face - front (a).1. Install the keyless buzzer.2. Connect the ground terminal to battery senso ...

Other materials:

Transfer clutch pressure test inspection
1. EXCEPT FOR OUTBACK MODEL1. Lift up the vehicle.2. Remove the rear exhaust pipe from center exhaust pipe.3. Remove the center exhaust cover.4. Set the transmission jack under the transmission.5. Remove the mounting bolt of rear crossmember.6. Lower the rear side of transmission until the transfer ...