Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Security and locks / Rear gate opener button / Inspection

Unit inspection

Preparation tool:

Circuit tester

1. Check the resistance between connector terminals.

Terminal No.	Inspection conditions	Standard
1 — 2	OPEN	Less than 5 -
1 — 2	CLOSE	1 M- or more

2. If the inspection result is not within the standard, replace the button - opener rear gate.

Removal

NOTE:• The button - opener rear gate is integrated with the rear lock button.• Open the panel - rear gate before disconnecting the ground terminal from battery sensor.1. Disconnect the gro ...

CAUTION:Make sure that the harness grommet is securely installed.If not properly installed, this may cause leaks.1. Install the button - opener rear gate and rear lock button.2. Install the garnish sw ...

Other materials:

Installation
CAUTION:• When removing, installing or replacing the VDCCM&H/U, VDCCM&H/U bracket, steering wheel or steering angle sensor (steering roll connector), perform “VSC(VDC) Centering Mode” of the VDC. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT• Before ...