Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Security and locks / Rear gate opener button / Installation

CAUTION:

Make sure that the harness grommet is securely installed.

If not properly installed, this may cause leaks.

1. Install the button - opener rear gate and rear lock button.

2. Install the garnish switch bracket to the garnish assembly - rear gate.

3. Install the garnish assembly - rear gate. Rear Gate Garnish > INSTALLATION

Tightening torque

4.5 N·m (0.4 kgf-m, 3.3 ft-lb)

4. Install the trim panel - rear gate. Rear Gate Trim > INSTALLATION

5. Connect the ground terminal to battery sensor. NOTE

Inspection

Unit inspectionPreparation tool:Circuit tester1. Check the resistance between connector terminals.Terminal No.Inspection conditionsStandard1 — 2OPENLess than 5 -CLOSE1 M- or more2. If the inspection ...

Rear inner remote

...

Other materials:

Removal
1. PARKING BRAKE HARNESS1. Disconnect the ground terminal from battery sensor. NOTE2. Lift up the vehicle, and then remove the rear wheels.3. Remove the bolt and nuts and remove the fuel tank protector.4. Remove the electronic parking brake harness.(1) Remove the connectors (a), (b) and (c), and th ...