Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Security and locks / Relay and fuse / Inspection

1. CHECK FUSE

1. Remove the fuse and inspect visually.

2. If the fuse is blown out, replace the fuse.

NOTE:

If the fuse is blown again, check the system wiring harness.

2. CHECK RELAY

1. Measure the resistance between relay terminals.

Terminal No.	Inspection conditions	Standard	Circuit
1 — 2	Always	1 M- or more
1 — 2	Apply battery voltage between terminals 4 and 3.	Less than 1 -

Terminal No.	Inspection conditions	Standard	Circuit
1 — 4	Always	1 M- or more
1 — 4	Apply battery voltage between terminals 2 and 3.	Less than 1 -

Terminal No.	Inspection conditions	Standard	Circuit
1 — 2	Always	1 M- or more
1 — 4	Always	Less than 1 -
1 — 2	Apply battery voltage between terminals 3 and 5.	Less than 1 -

2. Replace the relay if the inspection result is not within the standard value.

Location

Main fuse box (M/B)Fuse 15 A (body integrated unit)(A)Fuse 15 A (body integrated unit)(B)Fuse & relay box (F/B)Fuse 10 A (body integrated unit, immobilizer antenna)(C)Fuse 7.5 A (keyless access CM)(D) ...

Remote openers

...

Other materials:

Rear center seatbelt on Outback
Center seatbelt tongue plate Connector (tongue) Connector (buckle) Center seatbelt buckle WARNING Fastening the seatbelt with the webbing twisted can increase the risk or severity of injury in an accident. When fastening the belt after it is ...