Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Security and locks / Trunk opener button / Inspection

1. Using the Subaru Select Monitor, display «Rear gate/Trunk UNLOCK output» from «Data monitor».

2. Check that the display changes when the trunk opener button is operated.

3. If the display is not correct as the result of inspection, refer to “General Diagnostic Table” of the “KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS)” section. General Diagnostic Table > INSPECTION

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the garnish - trunk. Trunk Lid Garnish > REMOVAL3. Release the locks at both ends of the trunk opener button by pushing them with ...

Installation

1. Install the trunk opener button to the garnish - trunk.2. Install the garnish - trunk.3. Connect the ground terminal to battery sensor. NOTE ...

Other materials:

Dtc p2101 throttle actuator "a" control motor circuit range/performance
DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Improper idling• Poor driving performance• Engine stalls.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PRO ...