Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Vehicle dynamics control (vdc) / Hill hold switch / Inspection

1. Measure the resistance between connector terminals.

Preparation tool:

Circuit tester

Terminal No.	Inspection conditions	Standard
1 — 4	Switch OFF	1 M- or more
1 — 4	Switch ON	Less than 1 -

2. Apply battery voltage between the connector terminals to check lighting condition of illumination inside the switch.

Terminal No.	Inspection conditions	Specification
2 (+) — 3 (−)	Apply battery voltage.	Light ON

3. Replace the hill hold switch if the inspection result is not within the standard value.

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the cover assembly - front. Console Box > REMOVAL3. Release the claws and remove the hill hold switch. ...

Installation

1. Install the hill hold switch.2. Install the cover assembly - front. Console Box > INSTALLATION3. Connect the ground terminal to battery sensor. NOTE ...

Other materials:

How to use as crossbars
CAUTION Do not raise the bar higher than necessary. The base of the bar may be damaged. Be careful not to contact the bars while sliding them. Otherwise, the bars may be scratched or the latch portions may be damaged. Do not slide the bar more ...