Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Vehicle dynamics control (vdc) / Hill hold switch / Installation

1. Install the hill hold switch.

2. Install the cover assembly - front. Console Box > INSTALLATION

3. Connect the ground terminal to battery sensor. NOTE

Inspection

1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard1 — 4Switch OFF1 M- or moreSwitch ONLess than 1 -2. Apply battery voltag ...

Rear abs wheel speed sensor

...

Other materials:

Installation
CAUTION:If the steering wheel and steering angle sensor are removed, perform “VDC sensor midpoint setting mode” of the VDC. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT1. Before attaching a new roll connector, apply a thin coat of grease contained in the connec ...