Subaru Legacy BN/BS (2015-2019) Service Manual: Rear abs wheel speed sensor

Installation

1. Install the hill hold switch.2. Install the cover assembly - front. Console Box > INSTALLATION3. Connect the ground terminal to battery sensor. NOTE ...

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Lift up the vehicle, and then remove the rear wheels.3. Remove the trunk trim panel assembly - side (sedan model) or rear floor mat (OUTB ...

Other materials:

Installation
1. Check that the mark on the cap - pivot wiper faces up.2. Install the motor assembly - rear wiper.(1) Install the bolts, and install the motor assembly - rear wiper.Tightening torque:6 N·m (0.6 kgf-m, 4.4 ft-lb)(2) Install the harness connector of the motor assembly - rear wiper.3. Install ...