Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
CAUTION: • Be careful not to damage the sensor. • Do not apply excessive force to the sensor harness. 1. Install the rear ABS wheel speed sensor. NOTE: Check the identification (mark) on the harness to make sure there is no warpage. General Description > SPECIFICATION Tightening torque: Rear ABS wheel speed sensor: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 2. Install the grommet, and connect the rear ABS wheel speed sensor connector. 3. Install the trunk trim panel assembly - side (sedan model) or rear floor mat (OUTBACK model). • Sedan model: Trunk Room Trim > INSTALLATION • OUTBACK model: Install the rear floor mat and the spacer - rear floor mat. 4. Install the rear wheels. Tightening torque: Rear wheel: 120 N·m (12.2 kgf-m, 88.5 ft-lb) 5. Lower the vehicle. 6. Connect the ground terminal to battery sensor. NOTE |
Inspection
1. CHECK WITH SUBARU SELECT MONITOR1. Connect the Subaru Select Monitor to data link connector.NOTE:For detailed operation procedures, refer to “Application help”.(1) On «Start» display, ...
Other materials:
Adjustment
1. DIFFERENTIAL BEVEL PINION GEAR BACKLASH1. Disassemble the front differential assembly. Front Differential Assembly > DISASSEMBLY2. Select the adjusting washer from the table and install.Adjusting washerPart No.Thickness mm (in)8030380210.925 — 0.950(0.0364 — 0.0374)8030380220.975 — 1.000(0 ...
