Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Entertainment / Antenna / Installation

1. RADIO ANTENNA AMPLIFIER

1. Install the amplifier assembly - antenna.

Tightening torque:

12±3 N·m (1.2±0.3 kgf-m, 8.9±2.2 ft-lb)

2. Install the trim panel - rear pillar UPR LH. (Sedan model)

3. Install the trim panel - rear gate UPR. (OUTBACK model)

4. Connect the ground terminal to battery sensor. NOTE

2. XM SATELLITE RADIO/TELEMATICS ANTENNA

1. Install the antenna assembly - roof.

Tightening torque:

4.5±1.0 N·m (0.5±0.1 kgf-m, 3.3±0.7 ft-lb)

2. Install the trim panel - roof assembly. Roof Trim > INSTALLATION

3. Connect the ground terminal to battery sensor. NOTE

3. ANTENNA FEEDER CORD

1. Install the cord assembly - antenna feeder and the trim panel - roof assembly. Roof Trim > INSTALLATION

2. Install the floor mat.

3. Install the front cover - side sill and the cover side sill - front.

4. Install the passenger’s seat. Front Seat > INSTALLATION

5. Install the cover assembly - front and the console box assembly.

Tightening torque:

6.5 N·m (0.6 kgf-m, 4.8 ft-lb)

6. Install the audio assembly or navigation assembly. Audio > INSTALLATION

7. Connect the ground terminal to battery sensor. NOTE

4. TELEMATICS SUB ANTENNA

CAUTION:

After installing the center grille assembly, check that the air vent grille of the center grille assembly is inserted correctly into the air vent duct.

1. Install the telematics sub antenna.

2. Install the audio assembly or navigation assembly.

3. Install the heater control assembly.

4. Install the center grille assembly.

5. Install the combination meter assembly.

Tightening torque:

7 N·m (0.7 kgf-m, 5.2 ft-lb)

6. Connect the ground terminal to battery sensor. NOTE

Removal

1. RADIO ANTENNA AMPLIFIER• Sedan model1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE2. Remove the trim panel - rear pill ...

Other materials:

General diagnostic table inspection
1. IMMOBILIZER SYSTEMSymptomsNoteEngine does not start Diagnostics with Phenomenon > INSPECTION Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2784 ANTENNA CIRCUIT (PUSH ENGINE SWITCH) Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B278A PUSH ENGINE SWITCH POWER SUPPLY ...