Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. SATELLITE SWITCH ASSEMBLY CAUTION: • Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION • Do not allow harness and connectors to interfere or get tangled up with other parts. • If the steering wheel has been removed, make sure that the steering roll connector is not turned from the original position. • If the steering wheel and steering angle sensor (steering roll connector) are removed, perform “VSC(VDC) Centering Mode” of the VDC. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT • Securely install the switch. Improper insertion of the pin or claw of the switch may cause improper installation. 1. Install the satellite switch assembly. 2. Align the center position of the steering roll connector. Roll Connector > ADJUSTMENT 3. Install the steering wheel. Tightening torque: 39 N·m (4.0 kgf-m, 28.8 ft-lb) Clearance: Between cover assembly - column and steering wheel: 4 — 6 mm (0.16 — 0.24 in) 4. Install the driver’s airbag module. Driver’s Airbag Module > INSTALLATION 5. Connect the ground terminal to battery sensor. NOTE 2. TELEMATICS BUTTON The telematics button is a single unit with the overhead console or stereo camera cover assembly. For operation procedures, refer to “LIGHTING SYSTEM” section. Spot Map Light > INSTALLATION |
Inspection
1. SATELLITE SWITCH ASSEMBLY1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard6 — 2VOL (+)VOL (−)SEEK ()SEEK ()LISTR ...
Other materials:
Removal
1. Remove the clip (A), and loosen the clamps (B) and (C) securing the air intake boot.2. Remove the air intake boot from the air cleaner case (rear) and throttle body, and move it to the left side wheel apron.3. Remove the bolts securing the throttle body to the intake manifold assembly, and tilt t ...
