Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. INTAKE SIDE 1. Install the camshaft position sensor, and connect the connector to the camshaft position sensor. Tightening torque: 6.4 N·m (0.7 kgf-m, 4.7 ft-lb) 2. Install the fuel injector. Fuel Injector > INSTALLATION 3. Connect the ground terminal to battery sensor. NOTE 4. Install the collector cover. 2. EXHAUST SIDE 1. Install the camshaft position sensor, and connect the connector to the camshaft position sensor. Tightening torque: 6.4 N·m (0.7 kgf-m, 4.7 ft-lb) 2. Install the under cover. Front Under Cover > INSTALLATION 3. Lower the vehicle. 4. Connect the ground terminal to battery sensor. NOTE |
Inspection
1. CAMSHAFT POSITION SENSOR1. Disconnect the ground terminal from battery sensor. NOTE2. Prepare an oscilloscope.3. While pressing the section (A) shown in the figure, move the lock lever (B) in the ...
Other materials:
Dtc p0111 intake air temperature sensor 1 circuit range/performance bank 1
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:• Improper idling• Poor driving performanceCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mo ...
