Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Fuel injection (fuel systems)(h6do) / Crankshaft position sensor / Installation

1. Install the crankshaft position sensor to the cylinder block, and connect the connector to the crankshaft position sensor.

Tightening torque:

6.4 N·m (0.7 kgf-m, 4.7 ft-lb)

2. Install the service hole plug.

3. Install the throttle body. Throttle Body > INSTALLATION

4. Install the air intake boot. Air Intake Boot > INSTALLATION

5. Connect the ground terminal to battery sensor. NOTE

6. Install the collector cover.

Inspection

1. CRANKSHAFT POSITION SENSOR1. Disconnect the ground terminal from battery sensor. NOTE2. Prepare an oscilloscope.3. While pressing the section (A) shown in the figure, move the lock lever (B) in th ...

Electronic throttle control relay

...

Other materials:

Installation
1. Install the EGR control valve, and connect the connector to the EGR control valve.NOTE:Use a new gasket.Tightening torque:19 N·m (1.9 kgf-m, 14.0 ft-lb)2. Install the EGR pipe A. EGR Pipe > INSTALLATION3. Install the air intake boot. Air Intake Boot > INSTALLATION4. Connect the ground te ...