Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Fuel injection (fuel systems)(h6do) / Manifold absolute pressure sensor / Installation

1. Install the manifold absolute pressure sensor to the intake manifold, and connect the connector to the manifold absolute pressure sensor.

Tightening torque:

6.4 N·m (0.7 kgf-m, 4.7 ft-lb)

2. Connect the ground terminal to battery sensor. NOTE

3. Install the collector cover.

Inspection

1. Check that the manifold absolute pressure sensor has no deformation, cracks or other damages.2. Connect dry-cell battery positive terminal to terminal No. 3 and dry-cell battery ground terminal to ...

Mass air flow and intake air temperature sensor

...

Other materials:

Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Lift up the vehicle, and then remove the rear wheels.3. Remove the nut - axle.CAUTION:Do not loosen the nut - axle while the rear axle is loaded. Doing so may damage the hub unit COMPL.(1) Lift the crimped section of the nut - axle.(2) R ...