Subaru Legacy BN/BS (2015-2019) Service Manual: Mass air flow and intake air temperature sensor

Installation

1. Install the manifold absolute pressure sensor to the intake manifold, and connect the connector to the manifold absolute pressure sensor.Tightening torque:6.4 N·m (0.7 kgf-m, 4.7 ft-lb)2. Co ...

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Disconnect the connector (A) from the mass air flow and intake air temperature sensor, and remove the mass air flow and intake air temper ...

Other materials:

Removal
1. FRONT CUSHION RUBBER AND ENGINE MOUNTING BRACKET1. Fully open the front hood. NOTE2. Disconnect the ground terminal from battery sensor. NOTE3. Remove the air intake duct. Air Intake Duct > REMOVAL4. Remove the clip (A), and loosen the clamps (B) and (C) securing the air intake boot.5. Remove ...