Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Fuel injection (fuel systems)(h6do) / Mass air flow and intake air temperature sensor / Installation

1. Install the mass air flow and intake air temperature sensor, and connect the connector to the mass air flow and intake air temperature sensor.

Tightening torque:

1 N·m (0.1 kgf-m, 0.7 ft-lb)

2. Connect the ground terminal to battery sensor. NOTE

Inspection

1. CHECK THE MASS AIR FLOW SENSOR UNIT1. Connect the battery positive terminal to terminal No. 3 and the battery ground terminal to terminal No. 4, and connect the circuit tester positive terminal to ...

Oil flow control solenoid valve

...

Other materials:

Inspection
1. LATCHCheck if the latch operates normally.If the cable is faulty, replace the latch & actuator assembly - rear.2. ACTUATOR1. Check door lock operationCheck the door lock operation when battery voltage is applied between the connectors.Terminal No.Inspection conditionsStandard4 (+) — 1 (−) ...