Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
CAUTION: If lubricant is spilt over the exhaust pipe, wipe it off with cloth to avoid emission of smoke or causing a fire. 1. Before installing rear oxygen sensor, apply the anti-seize compound only to the threaded portion of rear oxygen sensor to make the next removal easier. CAUTION: Never apply anti-seize compound to the protector of rear oxygen sensor. Anti-seize compound: NEVER-SEEZ NSN, JET LUBE SS-30 or equivalent 2. Install the rear oxygen sensor. Tightening torque: 21 N·m (2.1 kgf-m, 15.5 ft-lb)
3. Install the front exhaust pipe. Front Exhaust Pipe > INSTALLATION 4. Lower the vehicle. 5. Connect the ground terminal to battery sensor. NOTE |
Inspection
1. Check that the rear oxygen sensor has no deformation, cracks or other damages.2. Measure the resistance between rear oxygen sensor terminals.Terminal No.Standard1 and 25.6+0.8 −0.6 - (when 20 ...
Throttle body
...
Other materials:
Inspection
1. CRANKSHAFT POSITION SENSOR1. Disconnect the ground terminal from battery sensor. NOTE2. Prepare an oscilloscope.3. While pressing the section (A) shown in the figure, move the lock lever (B) in the direction of the arrow to disconnect the connectors from the ECM in numerical order as shown in th ...
