Subaru Legacy BN/BS (2015-2019) Service Manual: Rear oxygen sensor

Installation

1. PULSATION DAMPER RH1. Install the pulsation damper RH to the fuel injector pipe RH.NOTE:Use a new gasket.Tightening torque:21.6 N·m (2.2 kgf-m, 15.9 ft-lb)2. Install the fuel pipe protector ...

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Lift up the vehicle.3. Remove the front exhaust pipe. Front Exhaust Pipe > REMOVAL4. Apply spray-type lubricant (004301003) or equivalen ...

Other materials:

Condition check
NOTE:When replacing CVTF, determine the condition inside the transmission body by inspecting the drained CVTF.Fluid conditionTrouble and possible causeCorrective actionMetal particles.Excessive wear of the internal of the transmission body.Replace CVTF and check if CVT operates correctly.Thick and v ...