Subaru Legacy Service Manual: Installation

Subaru Legacy Service Manual / Instrumentation driver info / Switches and harness / Installation

1. MID SWITCH

CAUTION:

• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION

• Do not allow harness and connectors to interfere or get tangled up with other parts.

• If the steering wheel has been removed, make sure that the steering roll connector is not turned from the original position.

• If the steering wheel and steering angle sensor (steering roll connector) are removed, perform “VSC(VDC) Centering Mode” of the VDC. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT

• Securely install the switch. Improper insertion of the pin or claw of the switch may cause improper installation.

1. Install the MID switch.

2. Align the center position of the steering roll connector. Roll Connector > ADJUSTMENT

3. Install the steering wheel.

Tightening torque:

39 N·m (4.0 kgf-m, 28.8 ft-lb)

Clearance:

Between cover assembly - column and steering wheel: 4 — 6 mm (0.16 — 0.24 in)

4. Install the driver’s airbag module. Driver’s Airbag Module > INSTALLATION

5. Connect the ground terminal to battery sensor. NOTE

2. TRIP RESET SWITCH

1. Install the switch assembly - trip reset.

2. Install the visor assembly - lower.

3. Install the cover assembly - instrument panel LWR driver.

4. Connect the ground terminal to battery sensor. NOTE

3. ILLUMINATION CONTROL SWITCH

1. Install the illumination control switch.

2. Install the cover assembly - instrument panel LWR driver.

3. Connect the ground terminal to battery sensor. NOTE

Inspection

1. MID SWITCH1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard3 — 2 (UP)i/SET (DOWN)All OFFApprox. 1 M- or more (UP)ONLes ...

Warning box

...

Other materials:

Dtc c1511 valve relay
DTC DETECTING CONDITION:A fault is detected if valve relay drive voltage failure is detected.TROUBLE SYMPTOM:• ABS does not operate.• EBD does not operate.• VDC does not operate.• Hill hold does not function.• EyeSight does not operate. (Models with EyeSight)WIRING DIAG ...