Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Lubrication(h4do) / Oil level switch / Installation

1. Install the oil level switch, and install the clip (A) to the oil pan upper.

NOTE:

• Use new O-rings.

• Apply a coat of engine oil to the O-rings.

Tightening torque:

6.4 N·m (0.7 kgf-m, 4.7 ft-lb)

2. Attach the clip (A) securing the harness, and connect the connector of the oil level switch to the engine harness.

3. Install the under cover. Front Under Cover > INSTALLATION

4. Lower the vehicle.

5. Connect the ground terminal to battery sensor. NOTE

6. Fill engine oil. Engine Oil > REPLACEMENT

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the under cover. Front Under Cover > REMOVAL3. Drain the engine oil. Engine Oil > REPLACEMENT4. Disconnect the oil level switch ...

Oil pan and strainer

...

Other materials:

Removal
CAUTION:Always remove the sensor assembly - headlight beam leveler before removing any parts related to the suspension.1. Disconnect the ground terminal from battery sensor. NOTE2. Lift up the vehicle.3. Remove the rear wheel on the left side.4. Remove the sensor assembly - headlight beam leveler.C ...