Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
CAUTION: • Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION • If the steering wheel has been removed, make sure that the steering roll connector is not turned from the original position. • If the steering wheel and steering angle sensor are removed, perform “VSC(VDC) Centering Mode” of the VDC. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT 1. Align the center position of the roll connector. Roll Connector > ADJUSTMENT 2. Install the steering wheel. Tightening torque: Steering wheel: 39 N·m (4.0 kgf-m, 28.8 ft-lb) Clearance: Between cover assembly - column and steering wheel: 4 — 6 mm (0.16 — 0.24 in) 3. Install the driver’s airbag module. Driver’s Airbag Module > INSTALLATION 4. Connect the ground terminal to battery sensor. NOTE |
Assembly
CAUTION:Securely install the switch. Improper insertion of the pin or claw of the switch may cause improper installation.1. Install the MID switch.2. Install the satellite switch.3. Install the cover ...
Inspection
1. PADDLE SHIFT SWITCH1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard3 — 4Operate the + side of paddle shift assembly a ...
Other materials:
Brake line inspection
1. BRAKE LINE1. Check for scratches, swelling, corrosion, traces of fluid leakage on the brake hoses or pipe joints.2. Make sure that brake pipes/hoses do not interfere with adjacent parts and there is no loose connector/clamp during driving.3. Check any trace of fluid leakage, scratches, etc. on ma ...
