Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. Before installation, check the following items. • Cable and rod are free from deformation. • Grease is applied sufficiently to rod joints. If grease is insufficient, add it as necessary before assembling the rod. 2. Install the latch and actuator assembly - front. CAUTION: Do not re-use the screws. Always replace with a new part. Tightening torque: 6.5 N·m (0.7 kgf-m, 5.2 ft-lb) 3. Install the rod clamp to the frame assembly - front door outer. 4. Install the sash COMPL - lower. Tightening torque: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 5. Install the sealing cover - front door. 6. Install the trim panel - front door. Door Trim > INSTALLATION 7. Connect the ground terminal to battery sensor. NOTE |
Inspection
1. LATCHCheck if the latch operates normally.If the cable or rod is faulty, replace the latch & actuator assembly - front.2. LOCK ACTUATOR1. Check door lock operationCheck the door lock operation when ...
Other materials:
Basic diagnostic procedure procedure
CAUTION:• Subaru Select Monitor kit is required for reading DTC, performing diagnosis and reading current data.• Before removal or installation, be sure to remove any foreign matter (dust, moisture, oil, etc.).• Registration of immobilizer may be needed after the replacement of con ...
