Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Security and locks / Front door latch and door lock actuator assembly / Inspection

1. LATCH

Check if the latch operates normally.

If the cable or rod is faulty, replace the latch & actuator assembly - front.

2. LOCK ACTUATOR

1. Check door lock operation

Check the door lock operation when battery voltage is applied between the connectors.

Terminal No.	Inspection conditions	Standard
4 (+) — 1 (−)	Apply battery voltage.	LOCK
1 (+) — 4 (−)	Apply battery voltage.	UNLOCK

2. Check position switch

Measure the resistance between connector terminals.

Preparation tool:

Circuit tester

Terminal No.	Inspection conditions	Standard
8 — 7	LOCK	1 M- or more
8 — 7	UNLOCK	Less than 1 -

3. Replace the latch & actuator assembly - front if it is found defective.

Removal

1. Raise the glass assembly - front door to the top position.2. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE3. Remove the trim p ...

Installation

1. Before installation, check the following items.• Cable and rod are free from deformation.• Grease is applied sufficiently to rod joints.If grease is insufficient, add it as necessary be ...

Other materials:

Dtc u0181 lost communication with headlamp leveling control module
DTC DETECTING CONDITION:No data is received from auto headlight beam leveler CM or SRF CM.TROUBLE SYMPTOM:The auto headlight beam leveler or SRF does not operate normally.STEPCHECKYESNO1.CHECK PERFORMING OF BASIC DIAGNOSTIC PROCEDURE.Was the basic diagnostic procedure performed up to STEP 8- Diagnos ...