Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
Subaru Legacy BN/BS (2015-2019) Service Manual / Security and locks / Front inner remote / Installation
1. Before installation, check the following items. • Cable is free from deformation such as fray. • Grease is applied sufficiently to cable joints. If grease is insufficient, add it as necessary before assembling the cable. 2. Install the remote assembly - door. 3. Install the trim panel - front door. Door Trim > INSTALLATION 4. Connect the ground terminal to battery sensor. NOTE |
Inspection
Check if the remote handle operates normally.• If the lever is faulty, replace the remote handle.• If the cable is deformed, replace the latch & actuator assembly - front. ...
Other materials:
Welcome screen and Good-bye screen
When the driver's door is opened and
closed after unlocking the door, the
welcome screen will appear on the multi
information display for approximately 20
seconds.
When the ignition switch is turned to the
"LOCK"/"OFF" position, the multi information
display gradually turns off (Good-bye
s ...
© 2017-2025 Copyright www.sulegacy.com
