Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Security and locks / Trunk lid latch and actuator assembly / Installation

1. Install the lock assembly - trunk lid.

Tightening torque:

7.5 N·m (0.8 kgf-m, 5.5 ft-lb)

2. Connect the ground terminal to battery sensor. NOTE

3. Install the trim panel - trunk lid. Trunk Room Trim > INSTALLATION

Inspection

1. LATCHCheck if the latch operates normally.If latch deformation, abnormal wear, or unsmooth lock operation is observed, replace the lock assembly - trunk lid.2. ACTUATOR1. Check door lock operationC ...

Trunk opener button

...

Other materials:

Dtc p0967 pressure control solenoid "b" control circuit high
DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:Engine speed increases abruptly, and can not start.1. ENGINE TYPE FBWIRING DIAGRAM:CVT control system CVT Control System > WIRING DIAGRAMSTEPCHECKYESNO1.CHECK INPUT SIGNAL FOR TCM.1) After driving with warm up condition, park t ...