Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. Apply a coat of spray type lubricant to the mating area of cushion rubber. 2. Install the rear exhaust pipe to cushion rubber. NOTE: After assembling, degrease the lubricant which was applied to the cushion rubber while removing/installing.
3. Install the bolts and self-locking nuts which secure the muffler to the rear exhaust pipe. NOTE: Use a new gasket and self-locking nut. Tightening torque: 48 N·m (4.9 kgf-m, 35.4 ft-lb)
4. Install the bolts, springs, and nuts which secure the center exhaust pipe to the rear exhaust pipe. NOTE: Use a new gasket. Tightening torque: 18 N·m (1.8 kgf-m, 13.3 ft-lb)
5. Lower the vehicle. |
Inspection
1. Check the connections and welded parts for exhaust leaks.2. Make sure there are no holes or rusting.3. Check the cushion rubber for wear or crack. ...
Other materials:
Touch screen operation
This system is operated mainly by the
keys on the screen.
When a screen key is touched, a beep
sounds. You can set the beep sound.
Refer to "Unit settings" .
NOTE
If the system does not respond to
touching a screen key, move your
finger away from the screen and touch
it agai ...
