Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
CAUTION: If the hook - rear seat is disconnected from the vehicle body, make sure to replace the hook - rear seat with a new part to prevent the decline of the fixed force of the seat.
1. Before installation, inspect the following items and replace any faulty part with a new one. • Curtain airbag sensor or connector is damaged. • Curtain airbag module has been activated. 2. Install the curtain airbag sensor. CAUTION: • Do not reuse the bolt and nut. Always replace with the specified new bolts and nuts. • When installing the sensor, insert the set pin on the backside of the sensor into the hole on the body side securely. Tightening torque: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 3. Install the cover side sill - rear and the trim panel - rear pillar LWR. 4. Install the side pad assembly - backrest. Tightening torque: 53 N·m (5.4 kgf-m, 39.1 ft-lb) 5. Install the rear seat cushion assembly. 6. Connect the ground terminal to battery sensor. NOTE |
Removal
CAUTION:• Refer to “CAUTION” of “General Description” before handling the airbag system components. General Description > CAUTION• If the hook - rear seat is disco ...
Other materials:
Dtc p0171 system too lean bank 1
NOTE:Refer to DTC P0175 for diagnostic procedure. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0175 SYSTEM TOO RICH BANK 21. OUTLINE OF DIAGNOSISDetect fuel system malfunction by the amount of main feedback control.2. EXECUTION CONDITIONSecondary ParametersExecution conditionClose ...
