Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
CAUTION: If the hook - rear seat is disconnected from the vehicle body, make sure to replace the hook - rear seat with a new part to prevent the decline of the fixed force of the seat.
1. Before installation, inspect the following items and replace any faulty part with a new part. • The side airbag sensor or connector are damaged. • Side airbag module has been activated. 2. Install the side airbag sensor. CAUTION: • Do not reuse the bolt and nut. Always replace with the specified new bolts and nuts. • When installing the sensor, insert the set pin on the backside of the sensor into the hole on the body side securely. Tightening torque: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 3. Install the seat belt retractor. Tightening torque: Front seat belt: General Description > COMPONENT 4. Install the cover side sill - front, cover side sill - rear, and the trim panel - center pillar LWR. 5. Install the rear seat cushion assembly. 6. Connect the ground terminal to battery sensor. NOTE |
Removal
CAUTION:• Refer to “CAUTION” of “General Description” before handling the airbag system components. General Description > CAUTION• If the hook - rear seat is disco ...
Other materials:
Inspection
• Check the forward clutch drum, internal gear, sun gear and forward clutch piston lip for wear or damage.• Inspect the drive plate facing for wear and damage.• Check the driven plate for discoloration (burnt color).• Check for worn snap ring, fatigue or damaged return spring ...
