Subaru Legacy BN/BS (2015-2019) Service Manual: Piston specification

Subaru Legacy BN/BS (2015-2019) Service Manual / Mechanical(h6do) / Piston specification

Refer to “Cylinder Block” for removal and installation procedures of pistons. Cylinder Block > REMOVAL Cylinder Block > INSTALLATION

Intake manifold vacuum inspection

1. Warm up the engine.2. Remove the collector cover.(1) Carefully pull up the rear of collector cover at two positions (A).(2) Carefully pull up the front of collector cover at two positions (B) while ...

Preparation for overhaul procedure

1. After removing the engine from the vehicle body, attach the ST to the engine as shown in the figure.NOTE:When using a commercially sold engine stand, follow the instructions of engine stand used.Ti ...

Other materials:

Dtc u0073 control module communication bus off
NOTE:For the diagnostic procedure, refer to LAN section. Basic Diagnostic Procedure1. OUTLINE OF DIAGNOSISDetect malfunction of CAN communication.Judge as NG when CAN communication failure has occurred.2. COMPONENT DESCRIPTION(Common Specifications)CAN Protocol 2.0 B (Active)Frame Format: 11 Bit ID ...