Subaru Legacy BN/BS (2015-2019) Service Manual: Power rear gate auto closer

Installation

1. Install the memory height switch.2. Install the cover assembly - instrument panel LWR driver.3. Connect the ground terminal to battery sensor. NOTE ...

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the trim panel - rear gate. Rear Gate Trim > REMOVAL3. Remove the power rear gate auto closer.(1) Disconnect the connector.(2) Re ...

Other materials:

Dtc p2747 intermediate shaft speed sensor "b" circuit no signal
DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Standing start problems• Shock occurs when engaging the lockup clutch.• Shock occurs when selecting shift position.1. ENGINE TYPE FBWIRING DIAGRAM:CVT control system CVT Control System > WIRING DIAGRAMSTEPCH ...