Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Power rear gate system / Power rear gate auto closer / Installation

1. Install the power rear gate auto closer.

Tightening torque:

25 N·m (2.5 kgf-m, 18.4 ft-lb)

2. Install the trim panel - rear gate.

3. Connect the ground terminal to battery sensor. NOTE

Inspection

1. LATCHPull the emergency lever to check that the latch operates properly.If latch deformation, abnormal wear, or unsmooth lock operation is observed, replace the power rear gate auto closer.2. ACTUA ...

Power rear gate buzzer

...

Other materials:

Removal
CAUTION:• Be sure to prevent water or oil from contacting the connector terminal of secondary pressure sensor. If adhesion occurs, replace with a new part.• When removing secondary pressure sensor, CVTF may let out. If CVTF has leaked, adjust the CVTF level after installing the secondary ...