Subaru Legacy BN/BS (2015-2019) Service Manual: Power rear gate rod

Installation

1. Install the power rear gate inner switch.2. Connect the ground terminal to battery sensor. NOTE ...

Removal

1. Hold the rear gate to the fully open position.2. Disconnect the ground terminal from battery sensor. NOTE3. Release the claws and then remove the cap - rear quarter pillar UPR LH.4. Remove the rod ...

Other materials:

Removal
CAUTION:Do not remove except when the PCV hose is broken.1. Remove the clip (A), and loosen the clamps (B) and (C) securing the air intake boot.2. Remove the air intake boot from the air cleaner case (rear) and throttle body, and move it to the left side wheel apron.3. Disconnect the PCV hose A from ...