Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Power rear gate system / Power rear gate rod / Inspection

Check the ball housing and ball stud (bracket rod - power rear gate) of the rod - power rear gate for excessive play, wear or bent. Replace the rod - power rear gate if defective.

Removal

1. Hold the rear gate to the fully open position.2. Disconnect the ground terminal from battery sensor. NOTE3. Release the claws and then remove the cap - rear quarter pillar UPR LH.4. Remove the rod ...

Installation

1. Install the new stop ring to the rod - power rear gate.CAUTION:• Do not reuse the stop ring.• Align the stop ring to the ball housing groove, and attach the ring by gradually applying f ...

Other materials:

Communication for initializing impossible
1. ECMIf the communication with ECM is not possible, refer to ENGINE (DIAGNOSTICS). Basic Diagnostic Procedure > PROCEDURE Basic Diagnostic Procedure > PROCEDURE2. BODY INTEGRATED UNITIf the communication with the body integrated unit is not possible, refer to BODY CONTROL SYSTEM (DIAGNOSTICS). B ...