Subaru Legacy BN/BS (2015-2019) Service Manual: Preparation tool

Subaru Legacy BN/BS (2015-2019) Service Manual / Front suspension / General description / Preparation tool

1. SPECIAL TOOL

ILLUSTRATION	TOOL NUMBER	DESCRIPTION	REMARKS
	99099AJ000	ENGINE HANGER	• Used for hanging power unit. • Used together with CHAIN BALANCER (99099AJ010).
	99099AJ010	CHAIN BALANCER	• Used for hanging power unit. • Used together with ENGINE HANGER (99099AJ000).
	18360AA020	HANGER	• Used for hanging power unit. • For H6 model.
	18360AA040	HANGER	• Used for removing and installing the cradle. • Used together with BOLT (18363AA050).
	18363AA050	BOLT	• Used for removing and installing the cradle. • Used together with HANGER (18360AA040).
	927680000	INSTALLER & REMOVER SET	Used for replacing the bushing front - front arm of front arm assembly.
	20299AG020	STUD BOLT SOCKET	Used for removing and installing the stud bolt for front arm installing portion.
	20399AG000	STRUT MOUNT SOCKET	• Used for disassembling and assembling strut assembly and shock absorber assembly. • Used for checking center nut torque of strut assembly and shock absorber assembly.

2. GENERAL TOOL

TOOL NAME	REMARKS
Alignment gauge	Used for measuring wheel alignment.
Alignment gauge adapter	Used for measuring wheel alignment.
Turning radius gauge	Used for measuring wheel alignment.
Toe-in gauge	Used for toe-in measurement.
Chain sling	• Used for hanging power unit. • Diameter: 6 mm (0.24 in) or 6.3 mm (0.25 in) • Length: 0.8 — 1 m (2.6 — 3.3 ft) • Chain inner width: 8.5 mm (0.33 in) or more • Chain external width: 23.5 mm (0.93 in) or less • Load capacity: 1.2 t (2646 lb) or more
Shackle	• Two units used for hanging power unit. • Attached to both end of chain sling and connected to engine hook. • Load capacity: 250 kg (551 lb) or more
Sling belt	• Used to remove and install the cradle. • Width: 35 — 40 mm (1.38 — 1.57 in) • Length: 2 m (6.6 ft) • Load capacity: 1 t (2205 lb) or more
Shackle	• Used to remove and install the cradle. • Load capacity: 500 kg (1103 lb) or more
Tie-rod ball joint puller	Used for disconnecting tie-rod end.
Dial gauge	Used for damper strut measurement.
Coil spring compressor	Used for disassembling and assembling strut assembly and shock absorber assembly.

Caution

• When performing any work, always wear work clothes, a work cap and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.• When disposing of strut COMPL - ...

Component

(1)Front mounting bracket (H6 model)(7)Main cushion rubberTightening torque: N·m (kgf-m, ft-lb)(2)Bracket(8)Stopper (OUTBACK model only)T1:45 (4.6, 33.2)(3)Front mounting bracket (H4 model)(9)S ...

Other materials:

Inspection
CAUTION:• Do not use water instead of coolant.• Refer to “RM” section for the recommended engine coolant. 1. Park the vehicle on a level surface.2. Make sure the engine coolant level in the reservoir tank is between “FULL” and “LOW” when the engine is ...