Subaru Legacy BN/BS (2015-2019) Owners Manual: Remote keyless entry system

Subaru Legacy BN/BS (2015-2019) Owners Manual / Keys and doors / Remote keyless entry system

CAUTION

Do not expose the remote transmitter to severe shocks, such as those experienced as a result of dropping or throwing.
Do not take the remote transmitter apart except when replacing the battery.
Do not get the remote transmitter wet. If it gets wet, wipe it dry with a cloth immediately.
When you carry the remote transmitter on an airplane, do not press the button of the remote transmitter while in the airplane.
When any button of the remote transmitter is pressed, radio waves are sent and may affect the operation of the airplane.
When you carry the remote transmitter in a bag on an airplane, take measures to prevent the buttons of the remote transmitter from being pressed.

For models with "keyless access with push-button start system", the access key is used as the transmitter for the remote keyless entry system. For models without "keyless access with push-button start system", the transmitter for the remote keyless entry system is located inside the key head.

The remote keyless entry system has the following functions.

Locking and unlocking the doors (and rear gate for Outback) without a key
Opening the trunk lid (Legacy) without key
Sounding a panic alarm
Arming and disarming the alarm system.
For detailed information, refer to "Alarm system" .

The operable distance of the remote keyless entry system is approximately 30 feet (10 meters). However, this distance will vary depending on environmental conditions. The system's operable distance will be shorter in areas near a facility or electronic equipment emitting strong radio waves such as a power plant, broadcast station, TV tower, or remote controller of home electronic appliances.

Unlocking

Perform steps 1 to 5 described in "Registration". NOTE You cannot unlock by PIN Code Access in the following cases. when the access key is within the operating ranges &nbs ...

Operating the access key

NOTE The remote keyless entry system will not be activated when the push-button ignition switch is in any position other than the "OFF" position. Access key Lock/arm button ...

Other materials:

Inspection
1. LATCHCheck if the latch operates normally.If the cable or rod is faulty, replace the latch & actuator assembly - front.2. LOCK ACTUATOR1. Check door lock operationCheck the door lock operation when battery voltage is applied between the connectors.Terminal No.Inspection conditionsStandard4 (+) � ...