Subaru Legacy BN/BS (2015-2019) Service Manual: Removal

Subaru Legacy BN/BS (2015-2019) Service Manual / Clutch system / Operating cylinder / Removal

CAUTION:

Brake fluid spilled on the vehicle body will harm the paint surface; therefore, wash it off with water and wipe clean quickly if spilled.

1. Disconnect the ground terminal from battery sensor. NOTE

2. Remove the clip (A) from the air intake boot.

3. Loosen the clamp (B) connecting the air intake boot and air cleaner case (rear).

4. Loosen the clamp (C) which connects the air intake boot and throttle body.

5. Remove the air intake boot from the throttle body, and move it to the left side wheel apron.

6. Disconnect the clutch hose.

CAUTION:

Cover the hose joint to prevent the brake fluid from flowing out.

(A)	Clutch hose
(B)	Operating cylinder

7. Remove the operating cylinder.

NOTE:During assembly, apply hydraulic oil to all parts.Recommended brake fluid:New FMVSS No. 116 DOT3 or DOT41. Install the piston spring.2. Insert piston into the operating cylinder.3. Install push r ...

Other materials:

Assembly
1. Place the dish plate, driven plate, drive plate and retaining plate neatly in this order on surface table.NOTE:Make sure of the direction of dish plate.2. Set the dial gauge to retaining plate, and read its scale.NOTE:The value, which is read in the gauge at this time, is zero point.3. Scale and ...