Subaru Legacy BN/BS (2015-2019) Service Manual: Assembly

Subaru Legacy BN/BS (2015-2019) Service Manual / Clutch system / Operating cylinder / Assembly

NOTE:

During assembly, apply hydraulic oil to all parts.

Recommended brake fluid:

New FMVSS No. 116 DOT3 or DOT4

1. Install the piston spring.

2. Insert piston into the operating cylinder.

3. Install push rod to the boot.

4. Install the boot and push rod.

Removal

CAUTION:Brake fluid spilled on the vehicle body will harm the paint surface; therefore, wash it off with water and wipe clean quickly if spilled.1. Disconnect the ground terminal from battery sensor. ...

Installation

NOTE:• Use a new gasket.• Be sure to install the clutch hose with the mark side facing upward.• Be careful not to twist the clutch hose during installation.• Before installing ...

Other materials:

63
Malfunction of vehicle speed signal variation is detected.TROUBLE SYMPTOM:Cruise control cannot be set. (Cancelled immediately.)Refer to DTC 22 for diagnostic procedure. Diagnostic Procedure with Cancel Code > 22NOTE:When the vehicle was suddenly accelerated on low μ road surface while VDC is OFF ...