Subaru Legacy BN/BS (2015-2019) Service Manual: Removal

Subaru Legacy BN/BS (2015-2019) Service Manual / Eyesight / Switches and harness / Removal

1. PRE-COLLISION BRAKE OFF SWITCH

1. Disconnect the ground terminal from battery sensor. NOTE

2. Remove the cover assembly - instrument panel LWR driver. Instrument Panel Lower Cover > REMOVAL

3. Release the claws and remove the pre-collision brake OFF switch (h).

2. LANE DEPARTURE WARNING OFF SWITCH

1. Disconnect the ground terminal from battery sensor. NOTE

2. Remove the cover assembly - instrument panel LWR driver. Instrument Panel Lower Cover > REMOVAL

3. Release the claws and remove the lane departure warning OFF switch (g).

3. EyeSight STEERING SWITCH

NOTE:

For the operation procedures for the EyeSight steering switch, refer to “CRUISE CONTROL SYSTEM” section. Cruise Control Command Switch > REMOVAL

1. PRE-COLLISION BRAKE OFF SWITCH/LANE DEPARTURE WARNING OFF SWITCH1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard6 — 8 ...

Other materials:

Installation
CAUTION:Be careful not to snag the harness.1. Install each connector and the drain tube - sunroof.Tightening torque:Connector holder: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb)Ground bolt: 13 N·m (1.3 kgf-m, 9.6 ft-lb)2. Install the cover side sill - front and the front cover - side sill.3. Instal ...