Subaru Legacy BN/BS (2015-2019) Service Manual: Switches and harness

Installation

CAUTION:• Do not remove the protective cover until just before installing the stereo camera cover assembly. Using the bolt and nut, install the stereo camera with the protective cover attached, ...

Removal

1. PRE-COLLISION BRAKE OFF SWITCH1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the cover assembly - instrument panel LWR driver. Instrument Panel Lower Cover > REMOVAL3. Relea ...

Other materials:

Installation
1. Install the knock sensor to the cylinder block, and connect the connector (A) to the knock sensor.Tightening torque:25 N·m (2.5 kgf-m, 18.4 ft-lb)NOTE:The knock sensor should be installed so that the center of the connector is positioned as shown in the figure relative to the front of engi ...