Subaru Legacy BN/BS (2015-2019) Service Manual: Removal
1. HIGH BEAM CAUTION: • Do not perform work with wet hands, because there is a possibility of electrical shock. • Do not leave the light assembly - head without the bulb for a long time. Dust, moisture, etc. entering the light may affect its performance. 1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the high beam bulb. Headlight Assembly > DISASSEMBLY 2. LOW BEAM CAUTION: • Do not perform work with wet hands, because there is a possibility of electrical shock. • Do not leave the light assembly - head without the bulb for a long time. Dust, moisture, etc. entering the light may affect its performance. 1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the low beam bulb. Headlight Assembly > DISASSEMBLY • Halogen type: Headlight Assembly > DISASSEMBLY • HID type: Headlight Assembly > DISASSEMBLY |
Headlight bulb
...
Installation
1. HIGH BEAM1. Install the high beam bulb. Headlight Assembly > ASSEMBLY2. Connect the ground terminal to battery sensor. NOTE2. LOW BEAM1. Install the low beam bulb. Headlight Assembly > ASSEMBLY2 ...
Other materials:
Dtc b1802 short in driver's airbag (to ground)
DIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:GND short circuit failure (shorted to ground in main harness, shorted to ground in roll connector, shorted to ground in driver’s airbag, shorted to ground in airbag CM internal circuit)CAUTION:Before performing ...
