Subaru Legacy BN/BS (2015-2019) Service Manual: Removal
1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the rear wheel LH. Tire and Wheel > REMOVAL 3. Lift up the vehicle. 4. Remove the rear mud guard LH. Mud Guard > REMOVAL 5. Disconnect the quick connectors of the vent tube (A), canister drain tube (B) and purge tube (C), and remove the tubes from tube clamp (D). NOTE: Disconnect the quick connector as shown in the figure. • Vent tube (A) and canister drain tube (B) (Slider color is red or green.)
• Vent tube (A) and canister drain tube (B) (Slider color is white.)
• Purge tube (C)
6. Disconnect the connector (A) from the canister and remove the harness clip (B). 7. Remove the canister.
8. Remove the canister protector.
9. Disconnect the vent tube (A), canister drain tube (B) and purge tube (C). NOTE: Disconnect the quick connector as shown in the figure. • Vent tube (A) and canister drain tube (B) (Slider color is red or green.)
• Vent tube (A) and canister drain tube (B) (Slider color is white.)
• Purge tube (C)
10. Remove the hose clamp (D).
11. Disconnect the drain tube (A). NOTE: Disconnect the quick connector as shown in the figure.
12. Remove the leak check valve assembly from the canister.
|
Canister
...
Inspection
1. Check that the canister has no deformation, cracks or other damages.2. Check that the tube has no cracks, damage or loose part. ...
Other materials:
Dtc u0073 control module communication bus off
NOTE:For the diagnostic procedure, refer to LAN section. Basic Diagnostic Procedure1. OUTLINE OF DIAGNOSISDetect malfunction of CAN communication.Judge as NG when CAN communication failure has occurred.2. COMPONENT DESCRIPTION(Common Specifications)CAN Protocol 2.0 B (Active)Frame Format: 11 Bit ID ...
