Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Emission control (aux. Emission control devices)(h4do) / Canister / Inspection

1. Check that the canister has no deformation, cracks or other damages.

2. Check that the tube has no cracks, damage or loose part.

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the rear wheel LH. Tire and Wheel > REMOVAL3. Lift up the vehicle.4. Remove the rear mud guard LH. Mud Guard > REMOVAL5. Disconn ...

Installation

1. Install the leak check valve assembly to the canister.Tightening torque:8 N·m (0.8 kgf-m, 5.9 ft-lb)2. Connect the drain tube (A).CAUTION:• Check that there is no damage or dust on the ...

Other materials:

Dtc p0131 a/f / o2 sensor circuit low voltage bank 1 sensor 1
DTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE TYPE FB (WITHOUT PUSH BUTTON ST ...